IV Extension Sets

* Removable Sure-Lok® Needle-Free Connector * Pinch Clamp * Rotating Male Luer Lock * DEHP-free * Latex-free * Sterile * Length: 8in * Priming Volume: 1.8mL

Flow Control Extension Set features: * IV Regulator with Injection Site * Length: 20 inches * 20 inch standard bore Extension Set * One Flow Controller * DEHP-Free * Latex-Free * Female Luer 'Lock with' Cap * Slide Clamp * Rotating Male Luer Lock * Poly Pouch * Designed to control IV fluid and medications using a 'regulator dial' to control the rate of infusion * Clear markings on the dial allow you to easily set a specific flow rate * Two types of needle-free connectors, the AMSafe® and MicroClave® clear * Sterile AMAFS107

Patriot regular bore extension set with detachable swabable valve, red pinch clamp and sliding spin-lock. Components and tubing do not contain DEHP or natural rubber latex. Approximate priming volume: 0.9ml. Length: 8in.* Regular bore* Detachable valve* Red pinch clamp* Sliding spin-lock

* Length: 8in * Priming Volume: 1.8mL * Removable Sure-Lok® Needle-Free Connector * Pinch Clamp * Rotating Male Luer Lock * DEHP-free * Latex-free * Sterile

The MedSource I.V. Administration Extension Sets give flexibility to healthcare workers so that they may provide better patient care during I.V. Therapy. Features: * Needleless for safety * Offers flexibility in a wide variety of clinical settings * Individually package * Sterile * Not made with natural rubber latex * DEHP Free * Non-pyrogeneic * Manufactured with Medical Grade PVC * 6in, Needleless Clear PRN * Roberts Clamp * Rotary Male Luer Lock * Approx. Priming Volume: 2.0 mL * Length: 6in

For rapid administration of medication or fluids in an emergency, Amsino’s single-patient-use pressure infusion IV extension set is available alone or pre-attached on a Primary IV set. * Made to withstand up to 400psig * With a MicroClave® Clear Needle-Free connector * Includes a rotating male luer lock * Purple Slide Clamp * Sterile ICB33122

* Priming volume: 1.6mL * Length: 8in (20cm) * Standard bore extension set * Bonded SafeDAY valve * Non-removable slide clamp * Sliding SPIN-LOCK connector * Components do not contain DEHP or natural rubber latex. BB352244

* Priming volume: 1.0mL * Length: 6in (15.2cm) * Bonded ULTRASITE valve * Non-removable slide clamp * SPIN-LOCK® connector * DEHP free * Latex free BB473447

8 inch extension, needleless, with Roberts Clamp, Medsource Connector and Rotary Luer Lock Connector.

* Length: 10in * Priming Volume: 0.98mL * Removable MicroClave® Clear Needle-Free Connector * Rotating male luer lock * Clamp * Sterile * Latex-free * DEHP-free

IV Extension Set, 9in w/ Removable Luer Lock (Safeday)

* Priming volume: 1.3mL * Length: 7.5in (18.8cm) * SPIN-LOCK® connector * DEHP free * Latex free

* Length: 6in * Priming Volume: 2.5mL * Female Luer Lock * Pre-Pierced Y-Site * Sure-Lok® Needle-Free Y-Site * Slide Clamp * Rotating Male Luer Lock * DEHP Free * Latex-free * Sterile AM000606

* Priming volume: 0.7mL * Length: 7in (18cm) * Small bore extension set with bonded ULTRASITE® valve * Kink-resistant tubing * Non-removable slide clamp * SPIN-LOCK® connector * Latex free BB474921

IV Extension Set features: * 7.6 inch Long * Standard Bore * Catheter * Male Luer lock adapter with retractable collar * Priming Volume: 0.96 ml * Non-DEHP

Extension set with Dial-A-Flo, female adapter, prepierced Y-site and Option-Lok male adapter California Proposition 65 Warning: ⚠ WARNING: These products can expose you to chemicals such as vinyl chloride, ethylene oxide, bisphenol-A (BPA), diisodecyl phthalate (DIDP), and/or di(2-ethylhexyl) phthalate (DEHP) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. The above warning is required under California’s Safe Drinking Water and Toxic Enforcement Act of 1986, more commonly known as “Prop 65”. Some ICU products may be sterilized using ethylene oxide and some ICU intravenous tubing and drip chambers are manufactured using polyvinyl chloride (PVC) that may contain vinyl chloride, DIDP and/or DEHP. Also, certain manifold, stopcock, connector, and check valve products are manufactured using polycarbonates that may contain BPA. This shipment may contain one or more of these products.

This Smallbore extension set features: * Clamp * Sterile * 7 inches * Latex-free * DEHP-free * Luer Lock Connector * Rotating male luer lock * With MicroClave® clear needle-free connectors

Filterflow® Filtered Extension Sets * Priming volume: 5.1mL * Length: 16in (40.6cm) * 0.2 micron filter * Female luer connector * 1 Injection site * On/Off clamp and Spin-lock® connector * Latex free * DEHP free * Sterile BB473989

* Priming volume: 0.7mL * Length: 6-1/2in (16-1/2cm) * SPIN-LOCK® connector * DEHP free * Latex free BBCSE8SL

* Pressure rated extension set, MaxPlus clear needleless connector, needleless y-site, male spin lock, pinch clamp* Labeled for use with low pressure power injectors up to 325psi and maximum flow rate of 10mL/sec

California Proposition 65 Warning: ⚠ WARNING: These products can expose you to chemicals such as vinyl chloride, ethylene oxide, bisphenol-A (BPA), diisodecyl phthalate (DIDP), and/or di(2-ethylhexyl) phthalate (DEHP) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. The above warning is required under California’s Safe Drinking Water and Toxic Enforcement Act of 1986, more commonly known as “Prop 65”. Some ICU products may be sterilized using ethylene oxide and some ICU intravenous tubing and drip chambers are manufactured using polyvinyl chloride (PVC) that may contain vinyl chloride, DIDP and/or DEHP. Also, certain manifold, stopcock, connector, and check valve products are manufactured using polycarbonates that may contain BPA. This shipment may contain one or more of these products.

Positive displacement needleless connector with clear housing for aspiration, injection or gravity flow of fluid upon insertion of a male luer fitting. Features: * High pressure bonded 8in (20cm) small bore extenstion set * DEHP free * Latex free * Priming volume: 0.5 mL * Set rated to 300 psi * Flow rate: 10 mL/sec

Small Bore Stopcock features: * 3-Way Stopcock with Swivel Male Luer Lock * Non-DEHP formulation * Latex-free * Lipid resistant * Non-PVC MX5311L

SmartSite® Needle-Free Valve, Luer Lock, DEHP-Free. Approximate priming volume: 0.1ml. Labeled for use with low pressure injectors up to 325 psi and maximum flow rate of 10 ml/second....1/EA 100EA/CS2000E